1. Cleaning
1.1 Regularly inspect the inside and outside of the ball valve for impurities and corrosion
1.2 Wipe the inside and outside of the ball valve with a clean cotton cloth, especially the sealing part and the electric actuator part
1.3 Check whether the ball valve is damaged or deformed, and if so, it needs to be replaced in time
2. Lubrication
2.1 The seals of the ball valve and the oil pipeline of the actuator should be filled with new grease every six months
2.2 Lubricating oil needs to be added to the interface part
2.3 Pay attention not to mix oil and water during the cleaning process, and it is recommended to use cotton cloth or brush alone
2.4 Use some types of lubricants in high and low temperature environments
3. Sealing
3.1 After cleaning and lubrication, check the seal of the ball valve to ensure that it is intact
3.2 If there is any damage or aging of the seal, it needs to be replaced in time
3.3 The seals of the ball valve and the oil pipeline of the actuator should be filled with new grease every six months
Fourth, inspection
4.1 In order to ensure the proper operation of the ball valve, it needs to be inspected at regular intervals
4.2 Check the sealing performance of the ball valve, if it does not meet the standard requirements, it needs to be overhauled or replaced
4.3 Check the fluid flow and pressure of the ball valve, if it does not meet the requirements, it needs to be debugged or replaced
4.4 Regularly check the connection between the actuator of the ball valve and the oil pipeline to ensure that it is firm
Jun 12, 2024
Leave a message
Ball Valve Maintenance Operation Procedures
Send Inquiry





